CEKOL C-14


WHITE ADHESIVE FOR TILES AND STONE • CEKOL C-14 is used for tilling marble, granite, stone and ceramic tiles to mineral substrates. • The product is an elastic, frost and water resistant adhesive for indoor and outdoor use. • It is characterised by good adhesion and high dripping resistance. • Recommended for fixing tiles to standard and heated surfaces. • It is a top quality dry compound of white cement, white mineral fillers and modifiers. APPLICATION PREPARATION OF THE SUBSTRATE Using a spatula, remove the remains of emulsion and oil paints, and loose grains of sand. The substrate should be clean, tight and free of grease. PRIMING Highly absorbent substrates should be primed with a deep penetrating primer CEKOL DL-80. PREPARATION OF THE MORTAR In order to prepare the adhesive, pour 1 kg of powder to 0.2-0.25 l of water (5 to 6.25 litres per 25 kg bag) and mix thoroughly. Then wait approx. 3 minutes and mix it thoroughly again. APPLICATION OF THE ADHESIVE Apply the adhesive to the prepared substrate using a toothed trowel in a layer of 3 to 5 mm. Capacity per 1 m2 – a trowel with 6 mm teeth: approx. 3 kg. Tile correction time: 10 min. Pot life of the adhesive: approx. 3 hours Setting time for walking and pointing: about 24 hours at 18°C. In the case of heated surfaces, switch the heating off before glueing the tiles. The heating may be switched back on no sooner than after at least 7 days. In the case of gluing outside and to improve the adhesion of highly absorbent and stoneware tiles, CEKOL C-14 should be applied by a continuous layer on both the substrate and the underside of the tiles. Temperature of application and substrate +5°C ÷ +25°C.